Maintenance of air mould arch

matters needing attention:

Don't drag the air mold back and forth on the ground, especially on the uneven ground.

Keep away from sharp objects such as communication cables, branches, hooks, etc.

Keep away from flammable materials.

When the wind force is above 5, it is not suitable to place the air mold arch.

Use of air mold:

First fix the power socket (220 V).

Open the air mold. There are obvious rope fastening buttons at the front and back or left and right of the air mold. Then open the zippers on both sides of the air mold, and plug in sandbags filled with sand. According to the size of the air mold, adjust the position and plug in the power supply. Generally, the air is almost full of air in about 10 minutes, and then it is erected and successful.

If the air mold is dirty, don't wash it with detergent. Use a dry or damp cloth to wipe it. Wipe part of it and roll it up.

The use of cartoon model

Check the equipment, 12V blower fixed on the card, 12V battery, charger and battery bag.

First, put the battery into the battery bag, cross the left and right sides of the body obliquely, open the zipper on the cartoon, first put your feet in, be sure to expose your feet to tie the wrist, connect the power supply of the fan according to the color of the positive and negative electrodes on the battery, and then put it on at the waist and pull the zipper.

At the end of the activity, first pull out the power supply, open the zipper, and finally come out again to avoid breaking the wire.

Battery capacity depends on the capacity, must be charged about 10 hours, 4 a can work 1.5 hours, 7 amperes can work 2-3 hours.